tisdag 23 december 2014

Mirror side LED

So, this project got stuck and I was feeling disturbed that I didn't finish it up. Long time ago. Then a guy sent me a link to Shapeways that 3D-print objects on demand. I've been ignoring the 3D-printing as the tolerances have been too bad and the end result very coarse. But Shapeways are using laser sintering for printing, which means that an object is sliced into very thin layers and each layer is then laser hardened into the previous. The tolerances are close to 0.1 mm. Of course it is not as good as injection moulding, it is good enough though. Actually I am now 3D-printing threads directly into the object. And as I see it; better that people can get the mirror end cap in one way than not at all.

So, the idea is to reproduce the Vanagon Multivan mirror end cap in a transparent plastic. With a transparent end cap it can be filled up with electronics, for example LED's that are connected to the blinker relay. The Vanagon side visibility is terrible and the position and blinker lights are low. This is an improvement for road safety. I've also made them in solid plastic for people who needs a replacement or want to paint their van in a new colour without electronics.
Both options are heat resistant to 80°C / 176°F.

First batch of test prints are coming this way. As soon as I have tested them, just order a pair yourself!

You can find them at the Shapeways page here.



måndag 17 november 2014

A vanagon is pretty useful

I made a balcony fence to a guy and suspected that I needed a trailer to transport it. But nah, it did fit in the trunk. :)

torsdag 17 juli 2014

The PVC hose test

PVC hose vs brake fluid test. This hose has been hanging since 2011 on the workshop wall to test if a standard air hose can take the brake fluid as a replacement hose in the Vanagon clutch system. As you can see, it is still dry and fresh.
The hose going to the slave cylinder can't be bought any longer, but now you know where you can find one that survives the fluid.

torsdag 17 april 2014

ALH TDI arrived!

Let the fun begin. It is time to start coding some ECU stuff.. :)

onsdag 16 april 2014

Steering wheel upgrade pt 2

The T4 wheel has the same size as the Multivan servo wheel. But the design of it makes the driving much nicer for the arms and hands. Bolt on!
I give this simple upgrade 5 Vanagons out of 5!

Pilot upgrade

A friend went to a scrap yard and collected an early T4 steering wheel for my T3. Thanks Abdullah!
everyone that did this update claims that the steering and comfort is much better. I think it will be great as the servo is super light even with the large SUV tires. To be continued...

fredag 11 april 2014

Fwd: Golf tdi motor

Time for an upgrade! :)
The m-TDI is running great, but I have no idea how many miles it has. I've always wanted a newer engine for several reasons (emissions, VNT turbo, more power without tuning etc) and now I found an ALH in decent condition with a serviced turbo and a newly replace vacuum system. And best of all, this engine has the oil filter replaced from the top! 
It means that if I make a skid plate, which also lowers noise, I don't have to remove it to replace the filter.